Stock & Special Keyseaters – How to Order

Orders or inquiries should contain complete information in order that
we may fully understand the job conditions. Please submit a drawing
or sketch advising: Bore diameter, length, tolerance and if open-ended
or blind. Type of material to be milled and if hardened, to what degree.
If multiple splining, advise spacing, etc. Advise all unusual slotting
shapes such as; full radius, radius arcs, chamfer or radius corners.
Please also include side angles etc.



Stock & Custom Keyseating::
Please submit a drawing which includes the following facts:
W- Width of keyslot
B -Work piece bore diameter
D -Depth of keyslot, if measured trough the center of cut
                                -or-
E- Depth of keyslot, if measured at edge of cut
O- Overall depth of cut, measured from bottom of slot to the opposite
wall of bore.

Overall depth of cut equals work piece bore plus Depth of slot
Advise all tolerances required.

Stock Keyseat